Acti Indoor PTZ on Dropped Ceiling with Flush Mount Manuel d'utilisateur

2013/12/09 Indoor PTZ Mounting on the Ceiling Using Flush Mount Installation Guide For Models: I91, I92, KCM-8111

www.acti.comInstallation Guide 10 Damage Requiring service Disconnect this video product from the power supply immediately and refer servicing to

www.acti.comInstallation Guide 2 Table of Contents Installation Procedures ... 3 Step 1: Drill a

www.acti.comInstallation Guide 3 Installation Procedures Use the Flush Mount when installing the camera on a dropped ceiling; there is space above

www.acti.comInstallation Guide 4 Step 2: Prepare the Flush Mount 1. Push to detach the cover ring from the mount as marked below. Then set the co

www.acti.comInstallation Guide 5 Step 4: Install the Mount 1. Insert the metal bracket through the hole until the ring edge is flat on the ceilin

www.acti.comInstallation Guide 6 3. Tighten the screws to secure the mount and make sure the network cable, power adaptor, and other cables (if n

www.acti.comInstallation Guide 7 Step 5: Connect the Cables and Optional Accessories 1. Insert a memory card into the camera card slot (if necess

www.acti.comInstallation Guide 8 2. Slide the camera clockwise to secure the hooks to the mount. Notice that the fixing bracket screw becomes ali

www.acti.comInstallation Guide 9 Safety Information Read these instructions You should read all the safety and operating instructions before using