ACTi B81 Manuel télécharger pdf (Page 15)

www.acti.com

Hardware Manual

Step 2: Open the Dome Cover

NOTE: To avoid scratches or leaving fingerprints on the dome cover, it is recommended to retain

the plastic covering the dome cover until the camera is completely installed. However, the plastic

has been removed on some of the pictures in this documentation to show clarity of the

procedures being described.

1. If the cables will pass through the surface, remove the metal cap covering the bottom hole

of the camera, and attach the cap to the side hole to close it. The cables will be routed to

pass this hole from the surface.

2. With the bundled hex screwdriver, loosen the three (3) screws securing the dome cover.

3. Carefully lift to open the dome cover and place it on the side of the camera.

NOTE: Do not abruptly lift the dome cover; it is attached to the camera with a spring wire.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 44 45

Pas de commentaire

ACTi B81 Manuel Page 15