Acti V21 Manuel d'utilisateur télécharger pdf (Page 28)

www.acti.com

Encoder Hardware Manual

Use the default IP address of a encoder:

If there is no DHCP server in the given network, the user may have to assign the IP addresses to

both PC and encoder manually to make sure they are in the same network segment.

When the encoder is plugged into network and it does not detect any DHCP services, it will

automatically assign itself a default IP:

192.168.0.100

Whereas the default port number would be 80. In order to access that encoder, the IP address of

the PC has to be configured to match the network segment of the encoder.

Manually adjust the IP address of the PC:

In the following example, based on Windows 7, we will configure the IP address to 192.168.0.99

and set Subnet Mask to 255.255.255.0 by using the steps below:

1 2 ... 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Acti V21 Manuel d'utilisateur Page 28