ACTi ENR-120 Guide d'installation télécharger pdf (Page 24)

www.acti.com

ENR-100 Series System Administrator’s Manual

ENR-140

Please follow the instructions below to install your hard disks in correct order to make sure

the physical disk locations accord with the Disk ID shown in ENR server’s Storage Device

List.

To start, TURN OFF THE DEVICE, open the front

cover, repeat the following steps to install the hard

disks into the disk bays.

Step 1 Remove the Tray

Slide the Lock Tab to the right, the Hinge Tab will

pop out by itself. Remove the four front panel screws,

and then remove the three back panel screws.

Pull the Hinge Tab to 90 degrees from the front, and

pull out the tray.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 138 139

Pas de commentaire

ACTi ENR-120 Guide d'installation Page 24