ACTi E66 Guide d'installation télécharger pdf (Page 10)

E-10



 Switches

The following switch settings corresponding to each Serial Interface need to be

signified. To set the switches, remove the PS-A’s Rear Cover and locate the fol-

lowing switches, next to the PS-A’s circuit board. For information about attaching/

removing the Rear Cover,

5. Installation



Removing and Installing

the Rear Cover The switches are located as follows;

COM1

PCI

COM3

BAT

• COM3 and COM4 cannot be used for +5V Output.

• Do not connect any pins to COM3 [NC].

• No. 5 pin (GND) for RS-232C (COM1,COM2,COM3, COM4) is the

signal ground. Be sure to connect the GND terminal to the other

unit’s SG (signal ground) terminal.

• Be sure to confirm what settings will be used by the other device

when setting the switches. Failure to do so can result in a unit

malfunction or damage.

• Whenever changing any PS-A switch settings, be sure to first turn

the PS-A’s power supply OFF. Failure to do so can cause a PS-A

malfunction.

• Connect the FG terminal line to the connector cover's PS-A con-

nector attachment screw.

• FG and SG terminals are internally connected in the PS-A. When

connecting to another device, be sure to create an SG shorting

loop in your system.

Use inch type (#4-40UNC) threads to hold the cable's set (attachment) screws

in place.

Switch

Location

Switch Name Description

A DIPSW1

8-point dip switch. Changes the Touch Panel communication method.

(Serial <---> USB) For details about DIPSW1, see Table (1). (If "Serial" is

selected, COM4 cannot be used.) Factory setting is same as settings of

"When using USB" described in Table (1).

B DIPSW2

10-point dip switch. Designates the communication method settings. For

details about DIPSW2, see Table (2).

Factory settings are all OFF. (RS-232C)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

ACTi E66 Guide d'installation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Caméras de sécurité ACTi E66