ACTi E41A Guide d'installation télécharger pdf (Page 20)

www.acti.com

Installation Guide

Installation Using the Corner Mount with Bracket and

Naked Cable

The pre-installed network cable comes with an Ethernet port (female connector), or known as a

“pigtail”. The length of the cable is around 14 ~ 35 cm (varies by model). The network cable and

gland are resistant to salt water, weak acid, alcohol, oil, grease and common solvents.

In case the installation environment requires a change of this network cable, such as the use of

an Ethernet cable with male connector, it is recommended to use exterior-grade Ethernet cables

(CAT5/CAT5e/CAT6); ordinary Ethernet cables are only designed for indoor use and may

deteriorate quickly when exposed to outdoor elements. Exterior-grade Ethernet cables are

waterproof and do not require a conduit.

To replace the pre-installed network cable, follow the step-by-step procedures in this section and

prepare the following:

 Screwdriver

 Ethernet cable without connectors

 RJ-45 Connector (x2)

 RJ45 Crimping Tool

 Pliers

NOTE: The above materials/tools are not included in the package.

14 cm ~ 35 cm

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Pas de commentaire

ACTi E41A Guide d'installation Page 20